Denon AVR-1513

Denon AVR-1513 5.1-channel HD-Audio recipient gives you an interesting 3D venue experience with strong encompass sound when you interface it to a TV and Blu-beam circle player that upholds 3D video. Its Compressed Audio Restorer innovation allows you to partake in a rich sound from any media. The front HDMI offers a simple association for your cell phones. What’s more, it has Quick Select buttons you can use to one-contact select an often utilized video source or encompass mode. The enormous person show makes the activity simple and just.

Specifications of Denon AVR-1513

Audio-Video Surround Receiver (2012-13

Dimensions: 434 x 151 x 319mm

Weight: 7.8kg

Tuning range: FM, MW

Power output: 75 watts per channel into 8Ω (stereo)

Surround output: 75W (front), 75W (center), 75W (rear)

Frequency response: 10Hz to 100kHz

Total harmonic distortion: less than 0.08%

Input sensitivity: 200mV (line)

Signal to noise ratio: 98dB (line)

Speaker load impedance: 6Ω to 16Ω

Digital inputs: coaxial, optical

Video Connections: HDMI, composite

There are a few technical issues which are very common we found in Denon AVR-1513 that we will discuss here:-

Solution:- If there is no power or no LED light or no display then 1st you need to check the power socket by changing it with some other device, if another device is working fine in the same socket that means the power socket(AC line voltage) absolutely fine. Now you need to check the power cable which should be connected firmly at the AC power socket of Denon AV receiver which is built at the backside cabinet.

If it is connected properly that means the system has technical issues which can be solved by doing this, just remove the back cabinet by unscrewing the 8 screws, then check the power supply PCB (circuit) which is built vertically at the AC power input section/side, then check the main fuse, if it is blown then change the main fuse with the same value( fuse value is measured by Ampere) now probably your system will turn on and your problem is solved.

If the fuse blown again after changing by new one within a fraction of second that means the power supply circuit(PCB) is short and you should visit to authorized service centre to check/ change the main Switching IC, bridge rectifier diode, main filter capacitor, 4148 diode, quarter watts resistor and few low voltage Zener diodes. After doing this your power supply will be wonderful and your AV receiver/amplifier will work like earlier.

Fault:- No audio from any channel.

Solution:- Make the system factory reset by pressing and holding the tuner + and tuner – buttons together in standby condition, release the two-button when the display starts flashing at an interval of about 1 second, then follow the instruction on the TV or projector screen, finish all the steps on screen, when complete it then try with input signal through HDMI cable. Hopefully, it will work.

Still, the problem still persists then try to update the firmware through USB which is freely available online.

If the problem still persists then check all the input signals like analogue coaxial and optical too, if there is no sound on any kind of signal mode that means the problem is in the HDMI card and it has to be replaced or to be repaired by authorised service Center.

If you found the HDMI card is perfect then the problem is in the preamplifier or main power amplifier section.