Denon AVR-1706

The Denon AVR-1706 conveys dynamic, room-filling surround sound from every one of your films, TV shows, music, and computer games. It merges the high-current intensification for seven speakers, high-level computerized handling, an abundance of comfort highlights, and Denon’s broadly rough development. The outcome is a strong and flexible recipient that will act as the core of an incredible home theatre framework.

Specifications of Denon AVR-1706: 

Audio-Video Surround Receiver (2005-06)

Dimensions: 434 x 147 x 417mm

Weight: 11.3kg

Tuning range: FM, MW                                     

Power output: 75 watts per channel into 8Ω (stereo)

Surround output: 75W (front), 75W (center), 75W (rear)

Frequency response: 10Hz to 100kHz

Total harmonic distortion: 0.05%

Speaker load impedance: 6Ω to 16Ω

Digital inputs: coaxial, optical

Video Connections: component, composite, SVHS

There are a few technical issues which are commonly found in Denon AVR-1706 that we will discuss here:- 

Solution:- If there is no power or no LED light or no display then 1st you need to check the power socket by changing it with some other device. If another device is working fine in the same socket that means the power socket absolutely fine. Now you need to check the power cable connected firmly to the AC power socket of the Denon AV receiver at the backside cabinet.

If it is connected properly that means the system has technical issues which can be solved by doing this, just remove the back cabinet by unscrewing the 8 screws, then check the power supply PCB (circuit) which is built vertically at the AC power input section/side, then check the main fuse, if it is blown then change the main fuse with the same value( fuse value is measured by Ampere) now probably your system will turn on and your problem is solved.

If the fuse blows again after changing by new one within a fraction of a second that means the power supply circuit(PCB) is short and you should visit the authorized service centre to check/ change the main Switching IC, bridge rectifier diode, main filter capacitor, 4148 diode, quarter watts resistor and few low voltage Zener diodes. After doing this your power supply will be absolutely fine and your AV receiver/amplifier will work like earlier.

Fault:- No audio from any channel.

Solution:- Make the system factory reset by pressing and holding the tuner + and tuner – buttons together in standby condition, and release the two-button when the display starts flashing at an interval of about 1 second. Then follow the instruction on the TV or projector screen, finish all the steps on the screen, and when complete it then try with the input signal through an HDMI cable. Hopefully, it will work.

If the problem still persists then try to update the firmware through USB which is freely available online.

In case, the problem still persists then check all the input signals like analogue coaxial and optical too, if there is no sound on any kind of signal mode that means the problem is in the HDMI card, therefore, repairing and replacing should be there by authorised service Center.

Still, if you found the HDMI card is perfect then the problem is in the preamplifier or main power amplifier section.