The DCD-1500AE highlights AL24 Processing, a simple waveform procreation innovation that DENON created to diminish quantitative noise and backing the higher goals and examine cutting-edge media. It incorporates the Original Drive Mechanism that DENON has been perfecting over numerous years for both committed and widespread CD players.
This Denon product purposes a 24-cycle D/A converter to perform D/A transformation. High sound quality is made conceivable with a very basic setup that utilizes just an extremely simple FIR filter in the result phase of the D/A converter
Specifications of Denon DCD-1500AE:
Super Audio CD Player (2005-10)
Dimensions: 434 x 135 x 331mm
Disc format: CD, SACD
Digital converter: PCM1791
Frequency response: 2Hz to 20kHz (CD), 2Hz to 50kHz (SACD)
Dynamic range: 100dB (CD), 104dB (SACD)
Signal to Noise Ratio: 110dB (CD), 104dB (SACD)
Total harmonic distortion: less than 0.0018% (CD), less than 0.0013% (SACD)
Line output: 2V
Digital outputs: coaxial, optical
Common faults that occur in Denon DCD-1500AE:
Power does not turn on / Power is turned off
Check whether the insertion of the power plug is correct into the power outlet.
This unit is in standby mode. Press the
button on the remote control.
The Auto Standby mode is set. The Auto Standby mode switches the unit to standby mode when the unit is not operated for approximately 30 minutes.
Interruption of sound or noise occurs
The sound may skip during playback of a CD-R/CD-RW containing a high-resolution audio source.
This may be caused by poor recording conditions, or the disc itself may be of poor quality. Use a correctly recorded disc.
Cannot playback Discs
There is dirt and scratches on the disc. Either clean the disc or insert a different disc.
Discs are not playing back unless they are finalized. Use a final disc.
The cause may be poor recording conditions, or the disc itself may be of poor quality. Use a correctly record disc. Files are created in a format that is not supported by this unit. Check the formats supported by this unit.
“ No Disc” is displayed if the loading of the disc is upside-down.
“Unsupported” is displaying if a disc that cannot be played is loaded.
Operations cannot be performed through the remote control unit
Batteries are worn out. Replace with new batteries.
Operate the remote control unit within a distance of about 7 m from this unit and at an angle of within 30°.
Operating range of the remote control unit link
Remove any obstacle between this unit and the remote control unit.
Insert the batteries in the proper direction, checking the and marks.
The unit’s remote control sensor is exposed to strong light (direct sunlight, inverter-type fluorescent bulb light, etc.). Move the unit to a place in which the remote control sensor will not be exposed to strong light.
When using a 3D video device, the remote control unit of this unit may not function due to the effects of infrared communications between units (such as TV and glasses for 3D viewing). In this case, adjust the direction of units with the 3D communications function and their distance to ensure they do not affect operations from the remote control unit of this unit.